CANAKIT USB PIC PROGRAMMER PIN CODE

#pragma config FCMEM = ON // Failsafe enabled Internal/External switch over #pragma config FCMEM = OFF // Failsafe Disabled

This option can be enabled by setting the FCMEM configuration bit. The fail-safe monitor allows the device to switch over to internal oscillators when external clock fails. Oscillator configuration bits вЂ“ PIC18F4550 Fail-safe clock monitor Other 12 registers are used for setting configuration bits for PIC18F4550. The last two are device ID registers which are read-only.

PIC18F4550 has 14 configuration registers, CONFIG1L, CONFIG1H, CONFIG2L, CONFIG2H, CONFIG3H, CONFIG4L, CONFIG5L, CONFIG5H, CONFIG6L, CONFIG6H, CONFIG7L, CONFIG7H, DEVID1, and DEVID2. Registers used for the setup of Configuration bits in PIC18F4550 The generated configuration bits can be used in the application by directly copying and pasting or saving it as a separate file and including it in the project. MPLAB X IDE has a configuration bits window to generate the directives based on the selected options. So it can only be accessed using table reads and table writes.Д¬onfiguration bits are directives written in the software.

CANAKIT USB PIC PROGRAMMER PIN CODE

These bits are mapped starting at program memory location 300000h.Д¬onfiguration bits are not accessible to the user through code because it belongs to the configuration memory space, not the user program memory space. They can be programmed to select various device configurations.

They can only be modified during programming time. Using these bits, we can essentially control where is the clock source, do the application needs watchdog timer etc. These are read during startup/reset and enable or disable different hardware features based on the values of bits. Configuration bits are special bits used for controlling different features in the Microcontroller.

Canakit usb pic programmer pin